Providing these reliable things are fine there is the chance that the cord running to the disposal has developed a short or a wire has become disconnected. You will need to disassemble the unit to verify all wires remain securely fastened. The last conclusion is that the motor has burned out, in which case you will need to replace the disposal unit.
After you have checked these areas, take a close look around the refrigerator, both inside and outside. Is there any usual condensation that could indicate a water leak somewhere? Is the icemaker hose fastened securely to the water line repair line? Check also for any water spots on the floor, as these are typically clear signs of a water leak somewhere.
One other common design that is considered "washerless" was made famous by Delta and copied by several other makers. It uses little "cup" seals that fit over springs recessed in the back of the valve body. The springs press these "seals" against the cartridge and regulate the flow through little tapered openings in the cartridge. If you have one of these and it's dripping, changing these springs and seals will usually correct it. Here's a tip. Once you have the cartridge out of the way, insert a phillips screwdriver into the seal and pop both the seal and spring out. Stick the new ones on the end of the screwdriver to help guide them into place. This is especially helpful if you don't have long slender fingers.
Once you have disconnected the tank remove it from your work space. Do a thorough measurement of the remaining pipe for reference when you go to the hardware store. I will be honest with you, you might need to make a few trips back to the store. Once you get the new tank, slide it into place to line up the plumbing.
The first step in the replacement project is to turn off the water line repair to the toilet and flush any water that may be in the tank. If you forget this step, you will have a giant mess to clean up! You should now disconnect that water line.
Plumbers should always have a durable and long lasting ventilation system ready for any job. Having clean air in ready supply can make many tougher jobs go much more smoothly and will cut down on the risk to the plumbers considerably.
A qualified plumbing company will not hesitate to show you its insurance policy. Make sure they are fully insured. Check if they have liability insurance and workers' compensation. Needless to say, you are putting yourself in danger if you hire a plumbing company with no insurance. Plumbers in Reading shows you its insurance policy up-front, no need to ask. We want you to know that it takes its work seriously and covers all the basics.